Users' questions 

How do I reset Ingenico iCT220?

Leia Doyle

How do I reset Ingenico iCT220?

Try a soft reboot.

  1. Hold down the clear button and the punctuation button (below the 9 key) at the same time for 3-5 seconds, until the terminal turns off.
  2. Once off, hold the enter button until the terminal powers on.
  3. Try the transaction again.

What is the admin password for Ingenico iCT220?

222222
Enter your Administrator password (the default is 222222) and press the green OK key.

How do I fix Ingenico?

How to fix your Ingenico

  1. Check to see if the Bluetooth is enabled in iOS.
  2. Check to see if the device appears in ‘My Devices’.
  3. If ‘My Devices’ shows the Ingenico, try tapping on Ingenico to reconnect the reader.
  4. If you can’t connect, try to reboot the iCMP by holding the # and < yellow buttons.
  5. Still no luck?

How do I activate Ingenico?

Connect the ethernet end of the connection cable to an ethernet port on your network’s router. Connect one end of the power adapter to the connection cable and the other end to a power outlet. After a few seconds, the terminal automatically powers on and an Activation Code displays on it’s white idle screen.

How do I reset my Ingenico Lane 7000?

Press the red “X” key followed by the green enter key to save and reboot your settings.

How do I reset my Ingenico card?

To restart an unresponsive Ingenico, hold down the #1,Cancel and Enter keys all at the same time and count to three before releasing. Information will scroll across the screen and the bottom will flash between “Ingenico” and “Initializing”.

How do I fix my Ingenico card reader?

How do I enable Ingenico iSMP?

Powering On/Off

  1. To power on the iSMP, connect the battery and press green key.
  2. To power off the iSMP, press pound (#) key + yellow key.

What are the safety instructions for the Ingenico ict220?

Important Safety Instructions Take care when unpacking, and inspect the product for any obvious external, or suspected internal damage. Page 4This apparatus is intended for use when supplied with power from a low voltage external power supply. • Only an Ingenico approved power supply (CE Marked) specified for use with this Terminal may be used.

How is the Ingenico ict220 modem connected to the PSTN?

Any cases of difficulty should be referred in the first instance to Ingenico. Connection The modem is connected to the PSTN via a standard plug and flexible cord, which requires a suitable compatible socket (and adaptor if required). Page 6: Declaration Of Conformity

How to setup an Ingenico Aqua payment terminal?

Payment Terminal Ingenico iCT220 Initial Setup Sircle pos (3 pages) Payment Terminal Ingenico iCT220 Quick Reference Manual (2 pages) Payment Terminal Ingenico Aqua Specifications Ingenico aqua payment terminals: specifications (2 pages) Payment Terminal Ingenico iCT220 Specifications

What kind of power supply do I need for Ingenico terminal?

• Only an Ingenico approved power supply (CE Marked) specified for use with this Terminal may be used. • Since this product does not have a disconnect device (ON/OFF switch), the Terminal and Power Supply must be installed near a suitable power socket which is easily accessible.